Create a tree branch with this steel frame on any healthy, compatible tree to hang the included 40" swing from
Using our proprietary design of ratchet straps and steel frame, Build-a-Branch can be used on any tree with a trunk diameter of 12” - 24"
The 360-degree spinning swivel attachment connects the swing ropes at a single point to allow for full motion turning
Assembly is easy and takes approximately 30 minutes to install
All parts needed for installation are included
Because of the simple ratchet system, Build-a-Branch can be taken down quickly for storage as needed
Holds up to 500 lbs
Build-a-Branch allows you to turn more trees into a swing tree! With this special set, including the Build-A-Branch and a 40" Adventure Sky Swing, you can turn any tree into a swing tree in just minutes! Gone are the days of depending on a specific type of tree branch to hang a swing in the backyard for the kids (or you!). Nearly 50% of tree branches in front and back yards are not compatible to hang swings from – until now!
Slackers Build-a-Branch is as simple and straightforward as its name, allowing you to create a strong tree branch that holds up to 500 pounds, on any healthy tree. The 360-degree swivel attachment allows kids to push and spin each other for non-stop fun and adventure in the yard!
Installation takes 30 minutes with our easy strap and ratchet system connecting at 2 points on the tree. The recommended installation process requires two adults, one 10 foot ladder, one hammer and a 12 foot measuring tape. The swing will hang from Build-a-Branch about 40” from the tree and be at least 24” off of the ground.
Specs + Material
Powder coated, weather-resistant steel frame
6000 pound break strength with steel buckle and 2” webbing
Compatible with tree trunks 12-24" in diameter
360-degree swivel attachment
Any swing used should hang at least 40” away from the tree and be at least 24” off of the ground